Showingof 104 item(s)
ONLY TO BE USED IN SQUARE KILNS. Cone Art uses premium “KA1” resistance wire. Each heating element is designed with a specific function in mind. Gauge of wire, watt load, and stretch ratio are all precisely calculated, to ensure maximum efficiency.
C$76.90
Cone Art uses premium “KA1” resistance wire. Each heating element is designed with a specific function in mind. Gauge of wire, watt load, and stretch ratio are all precisely calculated, to ensure maximum efficiency.
C$76.90
Cone Art uses premium “KA1” resistance wire. Each heating element is designed with a specific function in mind. Gauge of wire, watt load, and stretch ratio are all precisely calculated, to ensure maximum efficiency.
C$145.25
Cone Art uses premium “KA1” resistance wire. Each heating element is designed with a specific function in mind. Gauge of wire, watt load, and stretch ratio are all precisely calculated, to ensure maximum efficiency.
C$77.25
Rigidizer is a liquid which is used to harden the surface of fibre blanket. Ridigizer helps protect the blanket and also minimizes dust from the fibre. It can be thinned with water if required.
C$15.80
The Cone Art peep hole cover is made from a high quality stainless steel. It can be installed as a replacement on any kiln. They can’t be lost and they can’t be broken. No more searching for something to fill your peep hole so you can start your firing!
C$12.15
An automated switch that is mounted to the hinge of a kiln. When the lid is opened past the height of the prop, this switch ensures power to the heating coils is turned off so that you can never reach into a live kiln.
C$220.00
For use on Cone Art Kilns that were built in 2021 and after - this circuit breaker replaces the 0.5 amp fuse and fuse holder system.
C$16.15
This 0.5 Amp fuse is used in kilns to protect the digital control board from power surges.
C$5.75
Replacement wire for your Bead Tree. 2" long, sold in sets of 12 pieces.
C$17.85
A wiring harness is a complete kit of every wire and connector in your kiln, pre-cut to size, colour coded, labelled, and with connectors crimped on at the factory.
C$210.00
Piggyback terminal connectors, when crimped onto the end of a wire, allows a second tab connector to be connected to the same tab.
C$2.45
Cone Art uses premium “KA1” resistance wire. Each heating element is designed with a specific function in mind. Gauge of wire, watt load, and stretch ratio are all precisely calculated, to ensure maximum efficiency.
C$56.45
Cone Art uses premium “KA1” resistance wire. Each heating element is designed with a specific function in mind. Gauge of wire, watt load, and stretch ratio are all precisely calculated, to ensure maximum efficiency.
C$106.65