Kiln Supplies & Parts

You can upgrade from the standard VentMaster to the Controller Integrated Orton VentMaster when you purchase your kiln. It’s the same great vent, but hardwired to your kiln (it does not require a separate power source).

This terminal connection block is used to distribute power from the power cord to the rest of the kiln inside the control box. Our Cone Art terminal block is CSA/CUL approved for use as a connecting block for the main power input up to 90 amps.

Switch wire per foot . Available in 12 Gauge in Red, White and Black. Specify colour in the notes section at checkout.

A plug in connector for relay and switches.

A pilot light is used to indicate if an input switch is coming on - common to many older kilns.

Infinite Switch 120v

For use on Cone Art Kilns that were built in 2021 and after - this circuit breaker replaces the 0.5 amp fuse and fuse holder system.

This 0.5 Amp fuse is used in kilns to protect the digital control board from power surges.

Cone Plaques (holders) are designed to hold the cones at exactly the right angle so that they bend at the correct amount of heat work giving you accurate information about your firing.