Showingof 45 item(s)
This 0.5 Amp fuse is used in kilns to protect the digital control board from power surges.
C$5.45
A wiring harness is a complete kit of every wire and connector in your kiln, pre-cut to size, colour coded, labelled, and with connectors crimped on at the factory.
C$220.00
Piggyback terminal connectors, when crimped onto the end of a wire, allows a second tab connector to be connected to the same tab.
C$2.45
Dawson Claw Assembly with Guide Plate for Kiln Sitter.
C$29.50
* Please see notes at bottom of page before ordering.*
Tube Assembly for Dawson Kiln Sitter.
Tube Assembly for Dawson Kiln Sitter.
C$95.00
The Cone Art peep hole cover is made from a high quality stainless steel. It can be installed as a replacement on any kiln. They can’t be lost and they can’t be broken. No more searching for something to fill your peep hole so you can start your firing!
C$11.60
Switch wire per foot . Available in 12 Gauge in Red, White and Black. Specify colour in the notes section at checkout.
C$3.40
An automated switch that is mounted to the hinge of a kiln. When the lid is opened past the height of the prop, this switch ensures power to the heating coils is turned off so that you can never reach into a live kiln.
C$175.00
A pilot light is used to indicate if an input switch is coming on - common to many older kilns.
C$18.70
For use on Cone Art Kilns that were built in 2021 and after - this circuit breaker replaces the 0.5 amp fuse and fuse holder system.
C$15.40
Ceramic Element Lead Out Insulator Tube. 3.5” for Pottery Kiln, 2.5” for Glass Kiln - make your selection below:
C$4.50
Handle for Cone Art Kilns - all models. Screws included.
C$7.00
