The Gleco Trap is an innovative and inexpensive solution to messy, hard-to-use sink traps. The Gleco Trap provides you with an economical plumbing trap that is easily installed and maintained.

Invented by a plumber, the Gleco system revolutionizes the age-old chore of sink trap retrieval and plaster trap maintenance. No more leaky bags or bulky buckets!

Two sizes available! The GT64 is the most common package, suitable for most standard sinks. The GT43 is more appropriate for deep utility sinks or sink cabinets without much space underneath. 

Once the preassembled Gleco Trap is installed, replacing the bottle takes less than 90 seconds start to finish, without tools. Simply turn side valve to drain off excess water, unscrew full bottle, and screw in a clean one.

To determine the appropriate size needed, measure from the vertical center of the waste line to the floor under your sink.

GT43 Package - Needs a 13" minimum clearance

• Two 43 ounce bottles
• One lid for extra bottle
• One sink tailpiece 
• Two slip joint washers
• Four slip joint nuts
• One flat washer
• One extra O-ring
• Complete instructions

GT64 Package - Needs a 15.5" minimum clearance

• Two 64 ounce bottles
• One lid for extra bottle
• One sink tailpiece
• Two slip joint washers
• Four slip joint nuts
• One flat washer
• One extra O-ring
• Complete Instructions

Key Benefits:

• Adapts easily to existing plumbing, wherever there is a "P trap"/U shaped joint.
• Smaller bottle means less odors generated in and emitted from the trap.
• Translucent bottle enables you to see the contents of the trap at any time.
• The fill line easily and quickly shows when the trap needs to be serviced.
• Drain valve allows for all the water above the bottle to be drained prior to removal, eliminating spillage.
• Replacing the bottle takes than 2 minutes from start to finish, with no tools, no spillage, and no risk of coming into contact with the solids contained within the Gleco Trap.