Extruders

The Shimpo Hollow Die Extruder Set comes with eight dies as shown and the barrel insert to hold the dies in place. Just place the barrel and the hollow die in the Shimpo hand-held extruder and extrude hollow forms!

Part of the Bailey System Extruder line to be used with either the System 1 Manual Drive Frame or the System 3 Power Drive Frame. *Drive Frames must be purchased separately.

If you are extruding a large 8" square or round form, use this X shaped brace to support the outer corners of the inner die plate. This will prevent the corners of the inner die from flexing down under load and extend the life of your die.

Stainless steel braces to be used with Bailey's die sets. See below for further information.

5 x 6 aluminum die plate with various sized cut-outs. Includes Standard Die Brace and an insert to create a hollow tube. Walls of the tube are approx. 1/4" thick.

The EBX Clay Extruder Die Kit is a selection of large forms (4" - 8") for use with the Bailey 9" Clay Extruder and Barrels.